A curb chain hammered on its side into an S pattern.
Serpentine Gold Chains
Serpentine is made by swaging a curb chain while it stands on its edge. Stand a curb chain lengthwise on its side and the S pattern is already there; hammering brings it out.
Serpentine gold chains
Serpentine is produced by swaging - hammering - a curb chain while it is positioned on its side. If you stand a curb chain on its edge along its length, the S pattern is visible in the links already; the hammering accentuates it.
The result is a flat, close chain with a repeating S running down its face.
Swaging flattens the chain, so it reads as a single smooth band rather than as separate links, with a bright continuous line along the faces.
Flat chains of this kind are often worn on their own. A narrow serpentine and a broad one read very differently, so check the width on the product page.
Serpentine suits someone who wants a flat, fluid chain with a visible repeating pattern rather than a plain smooth band.
Width and length are on the product page where given.
Serpentine Gold Chains FAQs
What is a serpentine chain?
A curb chain that has been swaged, or hammered, while standing on its side. The hammering brings out the S-shaped pattern already present in the curb links and flattens the chain.
Is a serpentine the same as a snake chain?
No. They look alike at a glance but they are built differently: serpentine starts from a curb chain and is hammered, while a snake chain is assembled from stamped plates. Herringbone is the closer relative, since it is also a swaged chain.